Design of a 105 GHz notch filter based on the frequency selective surfaces
ID：151
Submission ID：121 View Protection：ATTENDEE
Updated Time：2023-11-20 13:53:23 Hits：451
Poster Presentation
Start Time：Pending （Asia/Shanghai）
Duration：Pending
Session：[No Session] » [No Session Block]
Presentation File
Tips: The file permissions under this presentation are only for participants. You have not logged in yet and cannot view it temporarily.
Abstract
For the protection requirements of the microwave diagnostic systems from damage by stray radiation, the microwave diagnostic systems on J-TEXT need a planar, lightweight, and low-cost notch filter structure. Without protection, this stray radiation can significantly damage the performance of the microwave diagnostic systems. To protect the microwave diagnostic systems, a frequency selective surface (FSS) is the suitable choice as a notch filter to attenuate stray radiation. The FSS notch filter should be located between the lenses of the microwave diagnostic systems. This paper presents a 105 GHz FSS notch filter for the microwave diagnostic systems on J-TEXT, and the S-parameters of FSS are calculated based on the equivalent circuit model. The parameters of FSS were determined using the particle swarm optimization (PSO) algorithm and full-wave analysis method optimization, and the factors influencing FSS have been examined. The research results of this paper provide a standard design flow.
Keywords
frequency selective surface,notch filter,equivalent circuit model
Speaker
Comment submit